Switching The Warning Tone; Selecting The Video Format; Setting The Rear View Camera - Pioneer AVH-5300DVD Operation Manual

Menu operations
Laying the panel down.
Returning the panel to the upright
position.
# As the set angle is saved, the LCD panel will
automatically be adjusted to the same position
the next time the LCD panel is opened.

Switching the warning tone

If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Display the system menu.
Refer to Introduction of menu operations on
page 39.
2 Touch DT.WARNING to turn the warn-
ing tone on.
# To turn the warning tone off, touch
DT.WARNING again.

Setting the rear view camera

(back up camera)
CAUTION
Pioneer recommends the use of a camera
which outputs mirror-reversed images.
Otherwise, the screen image will appear re-
versed.
This unit features a function that automatically
switches to the rear view camera video (REAR
VIEW CAMERA IN) when a rear view camera
is installed on your car and the gear shift is
moved to the REVERSE (R) position. (For
more details, consult your dealer.)
! After you set up the rear view camera set-
ting, move the gear shift to REVERSE (R)
and confirm that the rear view camera
video is shown on the display.
! Change this setting if the display switches
to the rear view camera video by error while
you are driving forward.
! To stop watching the rear view camera
video and return to the source display,
press and hold MUTE/ .
! Touch the RearView source icon to display
the rear view camera image while driving.
Touch the source icon again to turn the
rear view camera off. For details, refer to Se-
lecting a source using the touch panel keys
on page 10.
1 Display the system menu.
Refer to Introduction of menu operations on
page 39.
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit

Selecting the video format

You can switch the video output format of
REAR MONITOR OUTPUT between NTSC and
PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 39.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC—PAL
Note
You can switch the video output format only for
the source from this unit.
Section
11
51
En