Pioneer DVR-541H-S Operating Instructions Manual page 115

Additional information
Problem
No picture
All settings are reset
Remote control does
not work
No sound or sound is
distorted
Cannot switch a dual
mono program
The picture from the
external input is
distorted
The picture is distorted • Change the Input Line System setting (page 110). (You can also
Remedy
• Check that everything is connected properly (page 14).
• Check that the connected TV and/or the AV amp/receiver is set to
the correct input.
• The recorder may be set to progressive scan with an incompatible
TV. Reset to interlace by pressing and holding the front panel
button then pressing
• If the recorder is unplugged (or there is a power failure) while the
recorder is on, all the settings will be lost.
• Make sure that you switch the recorder into standby before
unplugging the power cord.
• If you connected this recorder to another Pioneer product using the
CONTROL IN jack, point the remote control at the other component to
use (page 14).
• Set the remote control to the same ID number as the recorder
(page 109). (When the batteries run down, the remote mode is
automatically reset to Recorder1.)
• Use the remote within its operating range (page 6).
• Replace the batteries (page 6).
• Make sure that the amp/receiver or TV is set to the correct input and
the volume turned up.
• There is no sound when the picture is paused, or during scanning or
slow motion play. Press
• DTS discs can only be played if this recorder is connected to a DTS
decoder or DTS compatible amp/receiver. If you have connected a
suitable decoder, also make sure that the Initial Setup > Audio Out >
DTS Out setting is On.
• Some 96 kHz discs do not output audio through the digital jack. In
this case, switch the input of your amp/receiver to analog.
• Check the audio cable connections (page 14).
• If the sound is distorted, try cleaning the cable plugs.
• During real-time copying it is not possible to switch audio channels.
The main and sub channels are both output.
• If the video signal from the external component is copy-protected,
you cannot connect via this recorder. Connect the component directly
to your TV.
change it by pressing the
front panel simultaneously with the recorder stopped.)
PLAY.
PLAY to resume regular playback.
STOP button and
STOP
OPEN/CLOSE on the
14
115
En