Operating Instructions - Central Pneumatic 95499 Assembly And Operation Instructions Manual

Pancake air compressor 2 hp - 4 gallon

Hide thumbs

Table Of Contents

Table of Contents

to Start the Compressor:

Check to make sure the Air Tank's Drain Valve (54), located at the bottom of the Air

Tank (50), is fully closed. Pull on the Safety release valve to verify that it is unstuck.

(See figure f.)

Turn the Air Outlet Valve (67) to its

Connect an air hose (not included) to the previously installed Quick Connector.

Then, connect the other end of the air hose to the pneumatic tool (not included)

that is to be used. (See figure f, next page.)

Plug the Power Cord (55) into the nearest 120 volt, grounded, electrical outlet.

up on the Pressure Switch (63) to its "StARt" position to turn on the unit.

Pull

(See figure f.)

When the Tank Pressure Gauge (62) reaches at least

Valve to its open position to allow air to the pneumatic tool. (See figure f.)

Once the air pressure reaches the pneumatic tool, observe the Tool Pressure Gauge

(65). Adjust the Regulator (66) to feed the proper PSI to the tool. To do so, turn

the Regulator clockwise to increase the PSI. Turn the Regulator counterclockwise

to decrease the PSI. (See figure f.)

NOtE:

When the maximum air pressure,115 PSI, is reached as indicated by the

Tank Pressure Gauge (62), the motor will stop. The Compressor will automatically

restart when the air pressure drops below 85 PSI. (See figure f.)

for technical questions, please call 1-800-444-3353.

SKU 95499