Operating Instructions - Central Pneumatic 97080 Set Up And Operating Instructions Manual

to Start the Compressor:
1. Check to make sure the Air Tank's Drain Valve (54), located at the bottom of the
Air Tank (53), is fully closed. Pull on the Safety Valve (25) to verify that it is not
stuck. (See Figures b and C.)
2. Plug the Power Cord (35) into the nearest 120 volt, grounded, electrical outlet.
3. Push in the "ON" side of the ON/OFF Power Switch (45) to turn the compressor
on. (See Figure b.)
Regulated Pressure
Gauge (70)
Pressure Regulator (24)
SKU 97080 For technical questions, please call 1-800-444-3353.

OPERAtING INStRuCtIONS

Figure b
Drain Valve (54)
ON/OFF Power Switch (45)
Figure C
Tank Pressure
Safety Valve (25)
Figure C
Gauge (26)
REV 07k
Page 9