Air Supply; Operating Instructions - Central Pneumatic 99659 Set Up And Operating Instructions Manual

Air Supply

1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram above. An in-line shut-
off valve is an important safety
device because it controls the air
supply even if the air hose is rup-
tured.
WARnIng! tO PREVEnt SERIOuS
InjuRY FROM ACCIdEntAl
OPERAtIOn: do not install a
female quick coupler on the tool.
Such a coupler contains an air valve
that will allow the air tool to retain
pressure and operate accidentally
after the air supply is disconnected.
note: Air flow, and therefore tool perfor-
mance, can be hindered by under-
sized air supply components.
2. The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
3. Inspect the air connections for leaks.
Repair any leaks found.

OPERAtIng InStRuCtIOnS

Read the EntIRE IMPORtAnt
SAFEtY InFORMAtIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
SKU 99659 For technical questions, please call 1-800-444-3353.
are found, do not use tool until
repaired.
tool Set up
do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. Improper
adjustment can result in tool
failure or other serious
hazards.
Work Piece and Work Area Set up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2. Route the air hose along a safe route
to reach the work area without creat-
ing a tripping hazard or exposing the
air hose to possible damage. The air
hose must be long enough to reach
the work area with enough extra
length to allow free movement while
working.
3. If an automatic oiler is not used,
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
To Inflate Automotive Tires:
4. Place the Air Compressor on a flat,
level, dry surface.
tO PREVEnt
SERIOuS InjuRY:
add
Page 7