Troubleshooting; Please Read The Following Carefully - Central Pneumatic 95499 Assembly And Operation Instructions Manual

Problem
Compressor will not start.
Low pressure.
Safety valve releasing.
Oil discharge in air.
Pressure switch will not turn off
Compressor.

PLEASE REAd tHE fOLLOWING CAREfuLLy

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
for technical questions, please call 1-800-444-3353.
SKU 95499

tROubLESHOOtING

Possible Cause
1. Blown fuse or circuit breaker tripped.
2. Loose electrical connections.
3. Bad Capacitors.
1. Restricted air filter.
2. Defective check valve.
3. Air leak in safety valve.
4. Defective Valve Plate.
1. Defective pressure switch.
2. Defective Safety Valve.
1. Too much oil in crankcase.
2. Compressor overheated.
3. Restricted oil breather cap.
Defective pressure switch.
Possible Solution
1. Replace or reset fuse/circuit breaker.
2. Make sure Compressor is plugged into a
working, 120 volt, grounded, electrical outlet.
3. Replace capacitors.
1. Replace air filter.
2. Have a qualified service technician replace
check valve.
3. Check valve by pulling on ring. If condition
persists, have a qualified service technician
replace valve.
4. Replace Valve Plate.
1. Have a qualified service technician replace
pressure switch.
2. Replace Safety Valve.
1. Drain crankcase and refill to proper level on
sight glass.
2. Reduce air pressure regulation.
3. Clean or replace oil breather cap.
Immediately unplug Compressor from its
electrical outlet. Do not operate Compressor
until a qualified service technician can replace
pressure switch.
Page 12