Screen Saver Mode; Setting Up The Unit Before Use - Panasonic KX-TG8070E Operating Instructions Manual

TG8070-8090E(e).book Page 11 Monday, June 11, 2007 8:12 PM
Battery level
Battery icon Battery level
High
@
Medium
?
Low
/
L When flashing: Needs
to be charged.
Panasonic Ni-MH battery performance
(supplied batteries)
Operation
In continuous use
In continuous standby
mode
Note:
L It is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
L Actual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
L Even after the handset is fully charged, the
handset can be left on the base unit or charger
without any ill effect on the batteries.
L The battery level may not be displayed correctly
after you replace the batteries. In this case,
place the handset on the base unit or charger
and let it charge for at least 8 hours.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Screen saver mode

If the handset is not on the base unit
or charger
The backlight will turn off completely after 1
minute of inactivity, even when:
– on a call
– operating the answering system
To use the handset when it is in screen saver
mode, activate the handset display again by:
Operating time
– pressing {^} or {V} when on a call or operating
10 hours max.
the answering system
– pressing {i} for all other times
100 hours max.
While charging
The backlight will be dimmed after 1 minute of
inactivity. The backlight can be turned off
completely depending on the setting (page 16). To
use the handset when it is in screen saver mode,
lift the handset to activate the handset display
again.
Setting up the unit before
use
Display language
1
2
3
4
5
Note:
L If you select a language you cannot read: {i}
i {MENU} (right soft key) i {>} 2 times i
{OK} (right soft key) i {V} 2 times i {OK}
(right soft key) i {V} 2 times i {OK} (right
soft key) i {^}/{V}: Select the desired
language. i {OK} (right soft key) i {i}
{i} i {MENU}
Select r by pressing {^}, {V}, {<}, or {>}.
i {OK}
Press {^} or {V} to select "Display Setup"
i {OK}
Press {^} or {V} to select
"Select Language". i {OK}
Press {^} or {V} to select the desired
language.i {OK} i {i}
Preparation
11