Table of Contents
Advertisement
Battery strength
Battery icon
1
2
3
Panasonic Ni-MH battery performance
(included batteries)
Operation
In continuous use
In continuous
standby mode
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Battery strength
High
Medium
Low
When flashing: Needs
to be charged.
Operating time
12 hours max.
150 hours max.
Screen saver mode
The backlight will turn off completely
after 1 minute of inactivity if the handset is
not on the base unit or charger.
To use the handset when it is in screen
saver mode, first press {ih} to turn the
display on again.
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Symbols used in these
operating instructions
Symbol
Meaning
Press " (middle soft key).
"
Proceed to the next operation.
i
Press # (middle soft key).
#
Select the mentioned handset
j
menu icon (page 8).
X
*1
K
Example: N (handset setup
*2
I
menu icon)
N
Select N by pressing {^}, {V},
L
{<}, or {>}.
M
" "
Select the words in quotations
shown on the display (e.g.,
"Time Settings") by
pressing {^} or {V}.
*1 KX-TG8100 and KX-TG8102 only
*2 KX-TG8120 and KX-TG8122 only
Preparation
11
Advertisement
Table of Contents
