Registering A Unit - Panasonic KX-TG8421E Operating Instructions Manual

TG8421E(e).book Page 27 Tuesday, December 16, 2008 8:03 AM
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 31) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L You must store the phone number
with an area code in the call barred
list.
■ From the caller list:
1
1 (centre of joystick) i j
i M
2
{V}/{^}: Select the entry to be
barred. i 1
3
{V}/{^}: "Add Bar List" i
M
4
{ih}
■ By entering phone numbers:
1
1 (centre of joystick) i #
i M i ~
2
Enter the phone number (24
digits max.). i M
L To erase a digit, press ^.
3
{ih}
Viewing/editing/erasing bar call
numbers
1
1 (centre of joystick) i # i
M
2
{V}/{^}: Select the desired entry.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming
L To exit, press {ih}.
3
Proceed with the desired operation.
■ Editing a number:
1 i {V}/{^}: "Edit" i
M i Use the joystick to move
the cursor. i Edit the number.
i M i {ih}
■ Erasing a number:
1 i {V}/{^}: "Erase" i
M i {V}/{^}: "Yes" i M
i {ih}
Note:
L When editing, press the desired dial
key to add, ^ to erase.

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit (page 28), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a "radio
cell".
27