Troubleshooting - Makita G1700I Instructions For Use Manual

13. TROUBLESHOOTING

When generator engine fails to start after several attempts, or if no electricity is available at the output
socket, check the following chart. If your generator still fails to start or generate electricity, contact your
nearest Makita factory or authorized service center for further information or corrective procedures.
When Engine Fails to Start:
Check if engine switch is in its proper position.
Check fuel level.
Check to make sure generator is not
connected to an appliance.
Check spark plug for loose spark plug cap.
Check spark plug for contamination.
Check engine oil level.
When No Electricity Is Generated at Receptacle :
Check if the Overload Lamp is turned ON
(Red) and/or AC breaker is turned OFF.
Check if the DC circuit breaker
is turned OFF.
Check AC receptacle and DC terminals for
loose connection.
Check to see if engine starting was
attempted with appliances already
connected to generator.
16
Turn engine switch to "
If empty, refill fuel tank making sure not to overfill.
If connected, turn off the power switch on the
connected appliance and unplug.
If loose, push spark plug cap back into place.
Remove spark plug and clean electrode.
If the engine oil level is low, add the oil to the
upper level line on the oil gauge.
Stop the engine and check the appliances
and/or generator for overloading. Depress
the circuit breaker into ON position.
Depress the circuit breaker into ON position,
after making sure the electric appliances
are in the normal condition.
Secure connection if necessary.
Turn off switch on the appliance, and
disconnect cable from receptacle. Reconnect
after generator has been started properly.
"(CHOKE) position.