Control Panel - Makita G1700I Instructions For Use Manual

(e) After 20 to 30 seconds of warm-up is completed, turn the engine switch to "
(f) Make sure the pilot lamp is on. This indicates that the generator is properly operating.
NOTE
Please consult with the Makita factory or authorized service center if the pilot lamp is turned off
during the proper operation.
2. USING ELECTRIC POWER
Make sure that the appliance is switched OFF before connecting it to the generator.
Do not move the generator while it is running.
Be sure to ground the generator if the connected appliance is grounded. Failure to
ground unit may lead to electrical shock.

CONTROL PANEL

G1700I (60Hz-120V)
1
11
(1) AC APPLICATION (See Fig. 4 4 -r r )
(a) Make sure the pilot lamp is turned on.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle. (See Fig. 4-r)
Check the amperage of the receptacles
used referring to TABLE 1, and be
sure not to take a current exceeding
the specified amperage.
Be sure that the total wattage of all
appliances dose not exceed the rated
output of the generator.
8
2 3 4 5
6
7
8
9
10
WARNING
q PILOT LAMP
w OVERLOAD LAMP
e OIL SENSOR LAMP
r AUTO POWER SAVE LAMP
t AUTO POWER SAVE SWITCH
y AC RECEPTACLES
u AC CIRCUIT BREAKER
i DC TERMINALS
o DC CIRCUIT BREAKER
!0 GROUND TERMINAL
!1 ENGINE SWITCH
Style Ampere Receptacle
NEMA
Up to 20A
5-20R
TABLE 1
" (RUN) position. (See Fig. 4-e)
AC plug Description
NEMA Duplex
5-20P Receptacle