Entering Gps Location Service; Viewing Your Position - Motorola TETRA MTH800 Feature User Manual

Entering GPS Location Service

To enter the GPS sub-menu, press
select More...> Location:
• Position provides the actual position infor-
mation.
• Interface allows you to enable/disable the
GPS location service.
• Testpage provides the actual satellite information.
Scroll to your selection and press
display.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
• The variation will vary in accordance to the GPS Configuration set by
your Service Provider.
• The availability of the GPS Location menus is dependent on your termi-
nal configuration, please contact your Service Provider for further
details.

Viewing Your Position

1. From the main menu,
lect More...> Location > Position.
2. Scroll to view the entire screen.
This displays the following information about
the last time your location was calculated (if available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
• The longitude expressed in degrees, minutes, and sec-
onds
• The altitude expressed in meters
• The number of satellites used to calculate the location. In
general, more satellites make for better accuracy. The
maximum is twelve satellites.
To calculate your location again, press Rfrsh.
64
and
to access the next
Select
and se-
press
Location
Position
Interface
Testpage
Select Back
Position
<Time>
<Latitude>
<Longitude>
<Altitude>
<Tracked satellites>
Rfrsh Back