Powering On (Emergency Button); Powering On With Transmit Inhibit (Txi) Active; Unlocking The Mth800 - Motorola TETRA MTH800 Feature User Manual

Powering On (Emergency Button)

Press and hold the Emergency button to power On.
The MTH800 will power On in Emergency Operation or in standard
mode (as programmed).

Powering On with Transmit Inhibit (TXI) Active

Transmit Inhibit is a feature allowing you to switch off transmission
before entering a Radio-Frequency (RF) sensitive area. To activate
this feature, press
> Activate.
Pressing the Emergency button, even if Transmit Inhibit is activated, causes
! !
the MTH800 to transmit immediately. The MTH800 must NOT be within the
W A R N I N G
RF sensitive area when entering Emergency Operation.
The TXI Mode remains active at power On. You will be asked
whether to leave the TXI Mode On or not.
Ensure you have left the RF sensitive area before deactivating Transmit
! !
Inhibit.
W A R N I N G
Press the Yes key to deactivate the TXI Mode. If the MTH800 was
previously used in Trunked Mode, it will register to the network. If
the MTH800 was previously used in Direct Mode, it will remain in
Direct Mode.
Press No in Trunked Mode and the MTH800 powers down; press
No in DMO and you remain in DMO with TXI selected.

Unlocking the MTH800

Your MTH800 may be locked at power up.
To unlock the MTH800 after powering on, enter the code at the
prompt. The MTH800 enters the default Home display.
The unlock code is originally set to 0000. Your Service Provider may
change this number before you receive your terminal.
12
and select More...> Networks > TXI Mode