Network Setup; Figure 19 ─ Network Menu; Figure 20 ─ Network General Setup Screen - Mitsubishi Electric DX-TL16U User Manual

Hide thumbs Also See for DX-TL16U:

Table of Contents

User's Manual

NETWORK SETUP

In the Main screen, use the Left or Right arrow buttons to display the Network menu.

Figure 19 ─ Network Menu.

General Settings (NETWORK  General Tab)

Figure 20 ─ Network General setup screen.

Highlight the first box beside Remote Watch – bps/ips. Press the Up and Down arrow buttons to set

the Transfer Speed from 50Kbps to 100Mbps or 0.1 ips to 30 ips.

Highlight the second box beside Remote Watch – bps/ips. You can select the unit of measure for the

transfer speed between: bps and ips. Press the

button to set the transfer speed.

NOTE: The local recording speed might be affected by various network bandwidth (Transfer Speed)

conditions.

Highlight the box beside Remote Watch – Quality and press the

button. You can select the Quality

from: Very High, High, Standard and Low. Press the

button to set the Quality.

NOTE: The higher Quality settings require higher Transfer Speed settings. The transfer speed you

set is the maximum speed. Depending on the network environment, this speed may not be achieved.

You can limit the network bandwidth settings so that system does not consume too much network bandwidth.

Highlight the box beside Network Bandwidth Limit and press the Up and Down arrow buttons to set the

desired maximum bandwidth from 50Kbps to 100Mbps.

Table of Contents

Dx-tl8u