Table of Contents
Advertisement
6. Answering Machine
Key
Remote command
Repeats a message (during
{1}
playback)
Skips a message (during playback)
{2}
Plays new messages
{4}
Plays all messages
{5}
Plays greeting message
{6}
Records greeting message
{7}
Stops current operation
{9}
Turns OFF auto answer setting
{0}
Erases a specific message (during
{*}{4}
playback)
Erases all messages
{*}{5}
Erases greeting message (during
{*}{6}
greeting message playback)
Ends remote operation
{*}{#}
Skips the greeting message
{#}
*1 If pressed within the first 5 seconds of a message,
the previous message will be played.
*2 To resume operation, press a command key within
10 seconds.
Recording a marker message
After playing back the messages, you can leave an
additional message.
1. Wait for 3 beeps indicating the end of the remote
operation.
2. Wait about 10 seconds.
3. Hear the voice guide.
4. Hear 1 beep.
5. Leave a message.
To turn ON the auto answer setting
1. Call your unit and let it ring 10 rings.
L A beep will sound.
2. Enter the remote operation ID (page 47, feature #11
on page 50) within 10 seconds.
L The receiving mode will be set to TAM/FAX or
FAX ONLY mode, depending on the setting of
feature #77 (page 54).
3. Hang up the handset.
Note:
L You cannot turn ON the auto answer setting in the
following cases:
– when the unit is set to TEL/FAX mode.
– when the unit is set to TEL mode and during night
mode (page 24, feature #35 on page 25).
48
*1
*2
Advertisement
Table of Contents
