Adjusting Positive Stops; Switch Action For The Lever Type Switch - Makita 2704 Instruction Manual

1
1. 90°Adjusting screw
2. 45°Adjusting screw
(A)
90
45
90 45
(B)
1. Arrow pointer
ON
OFF
1. Switch
8

Adjusting positive stops

006156
The tool is equipped with positive stops at 90° and 45° to the table surface. To
check and adjust the positive stops, proceed as follows:
Move the handwheel as far as possible by turning it. Place a triangular rule on
the table and check to see if the blade is at 90° or 45° to the table surface. If
the blade is at an angle shown in Fig. A, turn the adjusting screws clockwise; if
it is at an angle shown in Fig. B, turn the adjusting screws counterclockwise to
adjust the positive stops.
2
006157
After adjusting the positive stops, set the blade at 90° to the table surface.
006158
Then adjust the arrow pointer so that its right edge is aligned to the 0° gradua-
tion.
1
Switch action
For the lever type switch
006217
CAUTION:
• Before plugging in the tool, always be sure that the tool is switched off.
To start the tool, raise the switch lever. To stop it, lower the switch lever.
1