Cross Cutting - Makita 2704 Instruction Manual

1. Push stick
1
1. Auxiliary fence
1. Push block
2. Auxiliary fence
18
(2)
006171
1
(3)
006170
006220
1
2

Cross cutting

CAUTION:
• When making a crosscut, remove the rip fence from the table.
• When cutting long or large workpieces, always provide adequate support
to the sides of the table. The support should be at the same height as the
table.
• Always keep hands away from path of blade.
When the width of rip is 65 mm - 150 mm wide, use the push stick
to feed the workpiece.
When the width of rip is narrower than 65 mm, the push stick can-
not be used because the push stick will strike the blade guard. Use
the auxiliary fence and push block. Attach the auxiliary fence to the
rip fence with two "C" clamps.
Feed the workpiece by hand until the end is about 25 mm from the
front edge of the table. Continue to feed using the push block on
the top of the auxiliary fence until the cut is complete.