Installation; Positioning Table Saw - Makita 2704 Instruction Manual

INSTALLATION

525 mm
1. Hole diameter 8 mm
1
25 mm
2
1. 6 mm Std. washer
2. No.10 wood screw 40 mm min.
length
1
1. 6 mm Std. washer
2. 6 mm Mounting bolt & Nut tighten
securely
6

Positioning table saw

006145
Locate the table saw in a well lit and level area where you can maintain good
footing and balance. It should be installed in an area that leaves enough room
to easily handle the size of your workpieces. The table saw should be secured
620 mm
with four screws or bolts to the work bench or table saw stand using the holes
provided in the bottom of the table saw. When securing the table saw on the
work bench, make sure that there is an opening in the top of the work bench
1 the same size as the opening in the bottom of the table saw so the sawdust
can drop through.
If during operation there is any tendency for the table saw to tip over, slide or
move, the work bench or table saw stand should be secured to the floor.
006147
006243
2