Assembling Your Musketeer Advantage - Minelab Musketeer ADVANTAGE Instruction Manual

Instruction Manual

Assembling Your Musketeer Advantage

Please follow these simple instructions to assemble your new Musketeer
Advantage. Refer to the drawings to identify parts and how they are
positioned. If you have any difficulties, please contact your dealer for further
instructions.
Armrest / Upper Shaft Assembly
a) Remove the black nylon bolt and wing nut
(1) from the armrest (2).
b) With the cup of the armrest positioned up
(so that your arm rests in the cup and your
hand comfortably grips the foam handgrip),
slide the armrest (2) onto the end of the
black upper shaft (3).
c) Push the nylon bolt (1) through the holes
and tighten the wing nut by hand.
Lower Shaft Assembly
a) Unscrew the wing nut and remove the bolt (7) that is through the lower
fibreglass shaft (5). Ensure the washers do not fall out (6).
b) Remove the wing nut, bolt (7) and washers from the coil (8). These are
spare parts.
c) With the teardrop washers in place, push
the lower shaft (5) into the bracket on the
coil so that the holes line up.
NOTE:
Ensure that the stainless steel spring clip
located near the top of the fibreglass shaft
is pointing toward the rear of the coil.
d) Push the black nylon bolt (7) through the
holes in the bracket on the coil from the
cable entry side, then place the washer and
wing nut on the other end of the bolt and
tighten it by hand.
Figure 1 - Armrest
Assembly
Figure 2 - The coil and
lower shaft assembly
Page 7