Sound Settings - Panasonic CQ-D7400W Operating Instructions Manual

Sound settings

3
Setting
Select the
item.
SPEAKER : Select the speaker to be adjusted.
ALL
FRONT L : Front left speaker
FRONT R: Front right speaker
CENTER : Center speaker
L SUR : Rear left speaker
≥
R SUR : Rear right speaker
≥
BAND : The frequency to be adjusted is separated into
3 bands. Select the band you want to adjust from
among these 3 bands.
LOW: Low frequency range
MID: Midrange
HIGH: High frequency range
FREQ : Select the frequency to be centered on when you make
adjustments within each band (LOW/MID/HIGH).
GAIN : Set the amount (dB) by which the equalizer is to be
adjusted.
WIDTH : Set the bandwidth to be used when the equalizer is
adjusted. (The smaller the number, the sharper the
equalizer curve becomes.)
The following settings can be configured only when the
SPEAKER setting is set to ALL.
Preset memory
Loading the
preset settings
4
Finish the
Setting.
Note:
Press [DISP] on the
main unit or [RET] on
the remote control unit
to return to the regular
mode.
: All speakers
: The settings are preset
for each number. (1 to 6)
2 sec.
: The preset settings are
called.
SEL(Select)
DISP(Display)
RET
[RETURN]
Numeric
buttons
CAR DVD PLAYER / RECEIVER CAR DVD PLAYER / RECEIVER
Note:
≥ When playing a Dolby Digital/dts
source, the parametric equalizer
settings will not be implemented.
If no operation takes place for
≥
more than 60 seconds in the
settings, the display returns to
the regular mode.
The presets are common to all
≥
modes, and six types of settings
can be made. When the preset
settings are loaded, the preset
number which was last set for
each mode is loaded.
In the SPEAKER settings,
≥
adjustment values that are set for
an individual (except ALL)
speaker are shared among all
modes.
The CENTER/L SUR/R
≥
≥
settings cannot be made when
CENTER/SURROUND was set to
NONE in the SP SETUP setting
(page 36) for the adjustment
range of the SPEAKER setting.
CQ-D7400W
SET
SEL
(Select)
SUR
≥
43