Panasonic WV-CS650 Operating Instructions Manual page 33

(4) Camera Picture Setting (UP SIDE DOWN)
1. In this menu, it is possible to turn the picture upside down. Use
this menu as described below.
2. Move the cursor to UP SIDE DOWN and select ON by using the
joystick. The picture will be shown upside down, but the sides will
not be reversed.
(5) To restore the camera default position
Move the cursor to REFRESH by using the joystick and press the
F2 button of the WV-CU550A.
(For the WV-RM70, keep pressing the Right and Left switches
simultaneously for more than 2 seconds.)
(6) Camera Resetting
Move the cursor to CAMERA RESET by using the joystick and
press the F3 button of the WV-CU550A.
The camera is reset to the factory preset parameters.
(For the WV-RM70, keep pressing the Right, Left and Set
switches simultaneously for more than 2 seconds.)
(7) To close the SPECIAL menu
Move the cursor to RET and press the CAM (SET) key.
The setup menu appears on the monitor screen.
Note:
How to reset to the factory preset parameters
Any of the above settings plus the ALC/MANUAL level control and
phase adjustments can be reset to the factory preset parameters by
placing the cursor over the desired mode and then press the F2
button of the WV-CU550A.
(For the WV-RM70, keep pressing the Right and Left switches simul-
taneously for more than 2 seconds.)
- 30 -
** SPECIAL **
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL .I.......
–
UP SIDE DOWN OFF
REFRESH PUSH SW
CAMERA RESET PUSH SW
RET
** SPECIAL **
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL .I.......
–
UP SIDE DOWN OFF
REFRESH PUSH SW
CAMERA RESET PUSH SW
RET
** SPECIAL **
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL .I.......
–
UP SIDE DOWN OFF
REFRESH PUSH SW
CAMERA RESET PUSH SW
RET
** SPECIAL **
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL .I.......
–
UP SIDE DOWN OFF
REFRESH PUSH SW
CAMERA RESET PUSH SW
RET
+
+
+
+