Panasonic WV-CS400 Operating Instructions Manual page 19

Notes:
1. When the cursor "I" reaches to the end of "+" position, the cursor "I" jumps to the " " position. At the same
time, the step number of the "COARSE" mode increases one step to enable a continuous adjustment. The
reverse operation takes place when the cursor "I" reaches to the end of " " position.
2. When the Joystick is kept placing to right or left for more than one second, the cursor "I" moves quickly.
3. When F2 Button of WV-CU550A is pressed, both the coarse and fine adjustment are reset to the factory
setup position. (Factory setup position is zero-crossing of the AC line phase as shown below.)
4. If the AC line contains noise (spike noise etc.), the stability of the vertical phase of the camera video output
signal may be disturbed.
8. White Balance Setting (WHITE BAL)
(1) Auto-Tracing White Balance Mode (ATW)
• Display the Setup menu.
• If necessary, refer to Setup Menu Display, for details on displaying
the Setup menu on the monitor screen.
• Move the cursor to the "WHITE BAL" mode position and select the
"ATW" mode by using the Joystick.
• The white balance of the camera is automatically set.
• When manual adjustment of the white balance, press the CAM (SET)
Button to display the following field setup menu on the monitor
screen.
• In this menu, it is possible to mask areas. Move the cursor to the
"MASK SET" mode position and press the CAM (SET) Button. 48
Mask Areas appear on the monitor screen.
• Refer to the Back Light Compensation section on page 12, for details
about masking areas.
• After masking is completed, press the CAM (SET) Button for more
than 2 seconds. The previous field setup menu is then displayed.
• Move the cursor to the "R" position.
Control the Joystick to obtain the optimum amount of Red gain. The
cursor "I" moves to the left or right.
• Move the cursor to the "B" position.
Control the Joystick to obtain the optimum amount of Blue gain. The
cursor "I" moves to the left or right.
• Move the cursor to the "RET" position by using the Joystick and press
the CAM (SET) Button to return to the Set Up menu.
** SYNC **
V PHASE
COARSE 4(1---16)
FINE ......I..
RET
- 16 -
** SYNC **
V PHASE
COARSE 1(1---16)
FINE
+
RET
Camera setting menu
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SYNC
WHITE BAL
AUTO PAN
SPECIAL *
Camera setting menu
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC ON
SYNC INT
WHITE BAL
AWC PUSH SW
AUTO PAN OFF
SPECIAL *
ATW fine adjustment menu
* ATW *
R
B
MASK SET *
RET
.I.......
+
OFF *
ALC *
OFF
ON
INT
ATW *
OFF
....I....
+
....I....
+