Star Trac Pro S Owner's Manual page 44

Lowest
Item Value
DECELERA- 20
TION TIME
LOCK OUT -
LOCKOUT ID 10000
RAIL STOP -
10 REV 220
CNT/REV 31
MINIMUM 4
PWM
1/2 MAXIMUM 50
MAXIMUM 172
PWM
PERSON 1
DETECT 1
PERSON 1
DETECT 2
PERSON 1
DETECT 3
DATE 1.00
NO RAIL 0
STOP
KEY DOWN 0
SPEED CHG 0
ELEV STALL 0
ELEV RANGE 0
ELEV LOST 0
CHECK 0
MOTOR SYS
CHECK 0
SPEED SYS
ELEVATION 175
ZERO
42
Default Highest
Value Value Meaning
20 60 Time, in seconds, to reach 0 mph (0 km/hr) from maximum speed.
OFF - ON=Treadmill lock out enabled.
OFF=Treadmill lock out disabled.
12345 65535 Treadmill lockout ID.
OFF - ON=Enables handrail stop switch.
OFF=Disables handrail stop switch.
307 740 Tenths of inches of running belt travel for 10 flywheel revolutions, always
measured in tenths of inches. Nominal values are:
1.6" pulley: 275
1.7" pulley: 291
1.8" pulley: 307
2.1" pulley: 358
31 125 Number of counts for each motor shaft revolution. Values are:
RPM sensor at flywheel notches: 31
RPM sensor at motor shaft optical disk: 125
60 110 Pulse duty cycle to obtain the selected MN SPD. Divide MN PWM by 512 to
get % duty cycle.
260 340 Pulse duty cycle to obtain 1/2 maximum speed. Divide 1/2 MX by 512 to get %
duty cycle.
460 511 Pulse duty cycle to obtain the selected MX Spd. Divide MX PWM by 512 to get
% duty cycle.
150 150 NEED DESCRIPTION FOR THIS FUNCTION
150 150 NEED DESCRIPTION FOR THIS FUNCTION
150 150 NEED DESCRIPTION FOR THIS FUNCTION
1.98 12.99 Treadmill manufacture date.
0 65,535 Number of times Hand Rail Stop switch was down or disconnected on power-
up since last reset.
0 65,535 Number of times key other than 5 or 8 was down on power-up since last reset.
0 65,535 Number of times speed changed suddenly more than 2 mph (UNITS=English)
or 2 km/hr (UNITS=Metric) since last reset.
0 65,535 Number of times elevation failed to change (stalled) since last reset.
0 65,535 Number of times elevation was out of range (not between 0% and 15%) at
power-up since last reset.
0 65,535 After pressing S
went beyond 0% to 15%, since last reset.
0 65,535 Number of times the motor system was inoperable.
0 65,535 Number of times the speed system was inoperable.
240 242 Representation of voltage to elevation motor to obtain 0% elevation. Multiply
ELEV ZERO by 0.019608 to get actual voltage.
STAR TRAC PRO S / PRO / ELITE TREADMILL O
and reaching 0% reset, the number of times elevation
TART
' M
WNER S ANUAL