List of Functions
Others menu
Sub Menu
Trap IP Address 1
Trap IP Address 2
AMX Device Discovery
You can register up to two IP addresses for the SNMP
You can enter a number from 0 to 255 in each field of the address.
However, the following IP Addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a
network administrator.
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery
you are not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
Function
g
trap notification destination.
77
g
. Set this to Off if