Are images input from a port other than the Computer1 input port? The only images that can be displayed on an external monitor are computer images from the Computer1 input port.

Problems when projection starts

The projector does not turn on

Check

Did you press the [t] button?

Are the indicators switched off?

Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If

Is the Control Panel Lock set to Full Lock?

Is the correct setting for the remote receiver selected?

Adjust the Contrast setting from the Configuration Menu.

s Image Menu - Contrast

p.53

When the Lamp is nearly ready for replacement, the images become darker and the color quality becomes poorer.

When this happens, replace the Lamp with a new lamp.s

Press the [t] button to turn the power on.

The power cable is not connected correctly or power is not being supplied normally.

Disconnect and then reconnect the power cable.s Quick Start Guide

Check that your electrical outlet or power source is functioning correctly.

this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and