Recording With The Built-In Led Video Light (Nv-Gs35 And Nv-Gs21 Only) - Panasonic NV-GS35EP Operating Instructions Manual

ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
STILL ADV
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of
children.
≥If the remote control mode of the camera and
that of the remote control do not match with
each other, "REMOTE" will appear. When the
remote control is operated for the first time after
the camera is turned on, "CHECK REMOTE
MODE" ( ) will appear and operation is
-41-
impossible. Set the same remote control mode.
≥The remote control is intended for indoor
operation. Outdoors or under strong light, the
movie camera may not operate properly even
within the usable ranges.
16
LSQT0910
VOL
PAUSE STILL ADV
1
STOP
VAR
Before using
Recording with the built-in LED
video light (NV-GS35 and NV-GS21
only)
Gain up mode works with the built-in LED video
light to enhance the light's brightness and
brighten the natural colours in a scene.
1
Press the [LIGHT] button. 1
LIGHT
≥The built-in LED video light lights up and the
gain up mode is set to on.
≥The gain up mode will be brighter than when
only the LED video light is on, but ghost
images will appear.
2
Press the [LIGHT] button. 2
≥The gain up mode is set to off.
≥To eliminate ghost images, use this mode.
3
Press the [LIGHT] button. 3
≥The LED video light turns off.
≥Pressing the [LIGHT] button again returns to
1.
≥The subject should be within 1.5 metres of the
movie camera.
≥Using the LED video light reduces battery time.
≥Set the LED video light to off when not in use.
≥Do not look directly into the light.
≥If the LED video light is used with a conversion
lens attached, a slight vignetting (darkening
around edges) effect occurs on the screen.
≥Using the night view function at the same time
will make conditions even brighter.
≥The LED video light enables simply lightening
the images taken in a dimly-lit place. We also
recommend using it in a bright place to obtain
high quality images.
1
+
2
3