Microtek ScanMaker 9700XL Installing And Getting Started page 6

The ScanMaker 9700XL comes with two built-in interfaces: USB and SCSI. You may
choose any of the two interfaces to make the connection between the scanner and
computer. (You should use only one interface at a time.)
Before connecting the scanner, check to see if your computer system has a built-in
SCSI interface or an installed SCSI card. If you need help on installing the SCSI card,
please refer to the "SCSI Installation Guide" on separate documentation included in
your scanner package, or refer to the documentation that came with the SCSI card.
Follow the steps below to make the SCSI connection.
1. Shut down your computer.
2. Set the SCSI ID number to 6. If the SCSI ID number 6 is used by another SCSI
device, check which SCSI ID is free, and set the number to a free SCSI ID.
3. Connect the scanner to your computer, using the SCSI cable.
Connect one end of the SCSI cable to your computer's SCSI port, and connect the
other end of the cable to the scanner's SCSI port.