Microtek ScanMaker 5700 Install Manual

Installing and
Getting Started
for the ScanMaker
This document provides information on how to install your Microtek scanner on a PC or Mac using the scanner's
FireWire or USB interface and describes the features of the scanning.
Installation for PC and Macintosh
1. Unpack scanner
Open your scanner package and check major components
while referring to the Packing List. If any item is missing,
contact Microtek Customer Service.
Your Microtek ScanMaker 5700 scanner comes with
FireWire and USB FireWire FireWire FireWire FireWire USB USB built-in interfaces. See the figure below USB USB
to locate the different ports at the back panel of the
scanner, including the scanner's accessory port.
USB port
Trademarks
Microtek ® , ScanMaker ® , ScanWizard
registered trademarks of Apple Computer, Inc. Windows
holders.
Copyright © 2000 Microtek International Inc.
Power port
Accessory port
FireWire ports
® , FilmView TM are registered trademarks of Microtek International Inc. Macintosh
®
is a registered trademark of Microsoft Corporation. All other products or name brands are trademarks of their respective
®
5700
2. Unlock the carriage
1. With the scanner turned off, tilt the scanner on its side
to locate the carriage lever safety lock (located at the
bottom left side).
2. Slightly pull the lever towards you until you hear a
"click" which indicates that the scanner carriage has
been unlocked.
Power
switch
http://www.microtek.com
Version
Version
FireWire - Windows 98 SE, Windows Me,
Windows 2000, Mac G3/G4 and iMac DV
USB - Windows 98, Windows Me,
Windows 2000, Mac G3/G4 and iMac
Pull to unlock
carriage safety lock
® , Apple ® , FireWire ® and FireWire logo are trademarks or
I49-002920, August 2000