Table of Contents
Advertisement
2. Preparation
2.8 Your fax number
You can program your fax number so that it appears on
the top of each page sent.
1
{MENU} i {#}{1}{0}{3} i {SET}
2
Enter your fax number, up to 20 digits.
L To enter a "+", press {*}.
L To enter a space, press {#}.
L To enter a hyphen, press {RECALL}.
L To erase a number, press {STOP}.
3
{SET}
4
Press {MENU} to exit.
To correct a mistake
Press {<} or {>} to move the cursor to the incorrect
number, and make the correction.
L To erase all numbers, press and hold {STOP}.
20
{MENU}
{STOP}
{SET}
{RECALL}
{<}{>}
NO.=|
2.9 Configuring the unit to access
the LAN
You can print documents, scan documents, receive
faxes or send faxes using a computer on the LAN. To
enable these features, you need to set the IP address,
subnet mask, and default gateway for the unit.
Important:
L Consult your network administrator when setting
the IP address, subnet mask, and default
gateway.
2.9.1 Setting up automatically with a DHCP
server
Your situation:
– When only one unit is connected to the LAN.
If your network administrator manages the network with
a DHCP (Dynamic Host Configuration Protocol) server, it
will automatically assign an IP (Internet Protocol)
address, subnet mask, and default gateway to the unit.
1
After connecting the LAN cable to the unit and the
computer, connect the mains lead.
L The IP address, subnet mask, and default
gateway will be set automatically.
2
Install Multi-Function Station on the computer that
you want to use it with. See page 21 for details.
Note:
L You can connect two or more units and assign IP
addresses automatically with a DHCP server, but we
recommend assigning static IP addresses manually
for each unit to avoid unnecessary trouble.
2.9.2 Setting up manually
Your situation:
– When your network administrator does not manage
the network with a DHCP server.
– When two or more units are connected to the LAN.
You need to assign an IP address, subnet mask, and
default gateway manually.
1
{MENU} i {#}{5}{0}{0}
2
Press {0} to select "DISABLED" i {SET}
3
Set each item.
For the IP address:
1. Press {5}{0}{1}.
2. {SET} i Enter the IP address of the unit. i
{SET}
DHCP
=ENABLED
[V^]
IP ADDRESS
PRESS SET
Advertisement
Table of Contents
