Table of Contents
Advertisement
TCD200E(e-e).book Page 10 Wednesday, February 9, 2005 2:58 PM
Preparation
Note:
L When 7 flashes, recharge the handset
batteries. 7 will continue to flash until
the batteries have been charged for at
least 15 minutes.
L If the handset is turned off, it will be turned
on automatically when it is placed on the
base unit.
Battery life
After your Panasonic batteries are fully
charged, you can expect the following
performance:
Ni-MH batteries (700 mAh)
Operation
While in use (talking)
While not in use
(standby)
Note:
L Actual battery performance depends on a
combination of how often the handset is in
use (talking) and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
Battery replacement
If 7 flashes even after the handset
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
L We recommend the use of Panasonic
rechargeable batteries noted on page 4. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
L Do not mix old and new batteries.
10
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
1
2
Operating time
20 hours max.
Turning the power on/off
170 hours max.
Power on
Press {ih} for about 1 second.
L The display will change to the standby
Power off
Press {ih} for about 2 seconds.
L The display will go blank.
Setting the date and time
Important:
L Confirm that the AC adaptor is connected.
L Ensure that w is not flashing.
1
2
3
4
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 9 for battery installation.
mode.
Press {j/OK}.
Select "Handset Setup", then press
{>}.
Select "Time Settings", then press
{>}.
Select "Set Date & Time", then press
{>}.
Hide quick links:
Advertisement
Table of Contents
