Connections - Panasonic KX-TCD200E Operating Instructions Manual

TCD200E(e-e).book Page 8 Wednesday, February 9, 2005 2:58 PM
Preparation
Displays
Display icons
Various icons appear on the handset display
to indicate the current status of the unit.
Display Meaning
icon
Within range of a base unit
w
L When flashing: Handset
is searching for base unit.
(out of range of base unit,
handset is not registered
to base unit, no power on
base unit)
Handset is accessing base
L
unit. (intercom, paging,
changing base unit settings,
etc.)
Handset is on an outside
k
call.
Call bar is on. (page 22)
o
Battery strength
5
Voice enhancer is set to
[VE]
high or low tone. (page 13)
Night mode is on. (page 20)
[N]
Key lock is on. (page 13)
[X]
Handset number: The left
[2]
icon shows handset 2
example. (page 21)
Base unit number: The left
-2-
icon shows base unit 2
example. (page 21)
Line is being used by
another handset.
8 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333

Connections

When the AC adaptor is connected, a short
beep will be heard. If it is not heard, check
the connections.
Hooks
(220–240 V, 50 Hz)
To telephone
network
Important:
L Use only the AC adaptor and telephone
line cord supplied with this unit.
Note:
L If the AC outlet is connected to a switch,
make sure the switch is on.
L After connection, you must charge the
batteries to make or answer calls (page
9).
L Never install telephone wiring during a
lightning storm.
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a