Quick Start] [Off]/[On - Panasonic HDC-SD600 Operating Instructions Manual

[QUICK POWER ON]
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or
≥ Depending on the recording conditions, start time may be longer than 1 second in still
picture recording mode.
≥ In the quick power on mode, the zoom magnification becomes 1k.
[QUICK START]
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is
reopened.
≥ Start time will not shorten if there is no SD card inserted.
≥ Change the mode to
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is
set to or
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
j about 5 minutes elapsed
j mode is set to
≥ Time for quick start will be more than 0.6 seconds slower when digital cinema is used.
≥ Depending on the recording conditions, time for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 34) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
[OFF]/[ON]
.
[OFF]/[ON]
or .
.
35
VQT2V00