TP-Link TL-R470T+ User Manual page 41

Note:
If the LAN IP address is changed, you must use the new IP address to login to the router. To guarantee
a normal communication, please be sure that the Gateway address and the Subnet Mask of the Hosts
are consistent with that of the router accordingly.
4.3.2.2 DHCP
The router with its DHCP (Dynamic Host Configuration Protocol) server enabled can automatically
assign an IP address to the computers in the LAN.
Choose the menu Network→LAN→DHCP to load the following page.
The following items are displayed on this screen:
 DHCP Settings
DHCP Server:
Start IP Address:
End IP Address:
Figure 4-10 DHCP Settings
Enable or disable the DHCP server on your router. Select Enable to
make the router automatically assign TCP/IP parameters to the
computers in the LAN.
Enter the Start IP address to define a range for the DHCP server to
assign dynamic IP addresses. This address should be in the same IP
address subnet with the router's LAN IP address. The default address
is 192.168.0.2.
Enter the End IP address to define a range for the DHCP server to
assign dynamic IP addresses. This address should be in the same IP
address subnet with the router's LAN IP address. The default address
is 192.168.0.254.
-36-