Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain 2110 Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
To Add and Reprogram an Additional Hand-held Remote Control
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held
*
remote that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed, two clicks will be
heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds).
All previous codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical
USING THE MULTI-FUNCTION DOOR CONTROL
1. Press and hold the button on the
*
hand-held remote
to operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button
on the Multi-Function Door
Control.
3. Continue holding both buttons
while you press the push bar on
the Multi-Function Door Control
(all three buttons are held).
4. Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not
installed, two clicks will be heard.

*3-Button Remotes

If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
®
Security✚ 3-button
remote or mini-remote
can be programmed to
operate other
Security✚ ® garage door
openers.
31
® remote controls.
that you wish