Carton Inventory; Hardware Inventory; Assembly - Raynor ControlHoist ATS2113X-CX Owner's Manual

Carton Inventory

Your garage door opener is packaged in two cartons
which contain the motor unit and all parts illustrated
below. Accessories will depend on the model
Mounting Hardware
Rail Support
(Rail Support Bracket)
Bracket
"C" Wrap (2)
Safety Reversing Sensor
Mounting Bracket
With Square Holes (2)
Straight
Door Arm
Chain
Pulley Bracket

HARDWARE INVENTORY

Assembly Hardware
Washered Bolt, 5/16"-18x1/2" (2)
(Mounted in Opener)
Hex Screw 1/4"-20x5/8" (2)
Lock Washer 1/4"-20x5/8" (2)
Screw #8-32x3/8" (1)
Washered Bolt
5/16"-18x1/2" (2)
2 -Conductor Bell Wire
White & White/Red
Door Bracket
Safety Reversing Sensor
Mounting Bracket
With Slot (2)
Trolley
Safety Labels
and Literature
Installation Hardware
Hex Screw 5/16"-18x7/8" (4)
Nut 5/16"-18 (4)
Lock Washer 5/16" (4)
Rail Grease
Lag Screw 5/16"-9x1-5/8" (2)
Lag Screw 5/16"-18x1-7/8" (2)
Screw 6ABx1-1/2" (2)
Handle
Ring Fastener (3)
Carriage Bolt 5/16"-18x2-1/2" (2)
Insulated Staples (10)
Drywall Anchors (2)
Clevis Pin 5/16"x2-3/4" (1)
Clevis Pin 5/16"x1" (2)
Rope
purchased. If anything is missing, carefully check the
packing material. Parts may be stuck in the foam.
Hardware for installation is also listed below.
Lighted Door
Control Button
Curved Door Arm
Door Bracket Plate
Rail
Motor Unit
(2) Safety Reversing Sensors
(1 Sending Eye and 1 Receiving Eye)
with 2-Conductor White & White/Black
Bell Wire attached
Hardware for Safety
Reversing Sensor
Lag Screw 1/4x1-1/2" (4)
Carriage Bolt 1/4"-20x1/2" (4)
Lock Nut 1/4"-20 (4)
Wing Nut (2)
Hex Screw 1/4-20x1-1/2" (2)
Screw #10-32x3/8" (4)
Lock Nut #10x32 (4)
Insulated Staples (20)
5
Header Bracket with
Clevis Pin and Fastener
Styrofoam
Chain