Utilisation; Radio/Aux Operation; Setting The Alarm Time - Silvercrest KH 2352 Operating Instructions Manual

Utilisation

Device on/off switch
• Switch the device on by pressing the button
STANDBY/ON
on the front side of the device.
The green operational LED
• To switch the device back into the standby mode,
STANDBY/ON
press the button
green operational LED
• To switch the device off completely, remove the
plug from the power socket.

Radio/AUX operation

• First of all, switch the device on as described
above.
VOLUME/BUZZ
• Turn the regulator
you feel that a slight resistance has been overcome.
The Radio/AUX operation is now switched on.
• For radio operation, use the switch
to select either the wave band
In radio operation:
To select the radio station frequency
To select the radio station frequency, turn the tuning
regulator to either the left or the right. The station
frequency will be shown in the display.
• For playback of an external audio device, use
AUX/AM/FM
the switch
Adjusting the volume.
VOLUME/BUZZ
• Turn the regulator
to increase the sound level.
VOLUME/BUZZ
• Turn the regulator
decrease the sound level.
POWER
glows.
once again. The
POWER
extinguishes.
to the right, until
AUX/AM/FM
AM FM
or .
AUX
to select the setting
further to the right
to the left to

Setting the alarm time

1. Press and hold the button
appears on the display
2. Enter in the hour by repeatedly pressing on the
HOUR
button
3. Enter in the minutes by repeatedly pressing on
the button
4. Release the button
extinguishes. The alarm time is now programmed.
Alarm with the buzzer (BUZZ)
• To programme an alarm call with the buzzer,
turn the regulator
left, until you feel that a slight resistance has
been overcome.
Alarm with AUX-/Radio operation
• Turn the regulator
right, until you feel that a slight resistance has been
overcome, and then set the sound level at which
you wish to be woken.
• Using the switch
which you wish to be woken. If you wish to be
woken by the radio, tune in to a radio station
as described under "Radio/AUX operation".
Aktivating the alarm
• To activate the alarm, press the button
In the display the symbol
.
Note:
So that the alarm can switch itself on, the radio must
be in the standby mode.
Deactivating the alarm/Ending the alarm
• When the alarm has switched itself on, you can
switch the alarm off by pressing the button
AL.ON/OFF
. The alarm switches itself off, however,
it remains activated.
• To deactivate the alarm, press the button
OFF
until the symbol
tinguishes.
- 6 -
AL. SET
. A bell symbol
.
.
MIN
.
AL. SET
. The bell symbol
VOLUME/BUZZ
all the way to the
VOLUME/BUZZ
all the way to the
AUX/AM/FM
select the manner in
appears.
in the display ex-
AL.ON/OFF
.
AL.ON/