Kenwood SJ980 series User Manual

●
before using your Kenwood Never put the kettle near or on
appliance cooker hot plates or gas burners.
● ●
Read these instructions carefully This kettle is for boiling water only.
●
and retain for future reference. Failure to observe these cautions
●
Remove all packaging and any may result in damage to the kettle.
●
labels. This appliance is not intended for
use by persons (including children)
safety
with reduced physical, sensory or
mental capabilities, or lack of
●
Always use the filter and never
experience and knowledge, unless
overfill - boiling water may splash
they have been given supervision or
out.
instruction concerning use of the
●
Avoid contact with steam coming
appliance by a person responsible
out of the spout area when pouring
for their safety.
and out of the lid when refilling.
●
Children should be supervised to
●
Beware: the metal body of the
ensure that they do not play with
kettle will get hot during operation.
the appliance.
●
Keep small children away from the
●
Only use the appliance for its
kettle and never let the cord hang
intended domestic use. Kenwood
down over the worktop edge - a
will not accept any liability if the
child could grab it and pull the
appliance is subject to improper
kettle down.
use, or failure to comply with these
●
If you do not need so much cord,
instructions.
shorten it by winding any excess
before plugging in
cord inside the powerbase .
●
Make sure your electricity supply is
●
Always unplug your kettle
the same as the one shown on the
when not in use.
underside of your kettle.
●
Never put the kettle, powerbase,
Important – UK only
cord or plug in liquid.
● ●
Do not use if there is any damage The wires in the cord are coloured
to the kettle, powerbase, cord or as follows:
Green and Yellow = Earth,
plug. Get it checked or repaired:
see 'service'. Blue = Neutral,
●
Brown = Live.
Caution: Do not operate the kettle
●
The appliance must be protected
on an inclined surface.
●
Only use the powerbase supplied by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE
and keep it clean and dry.
●
Make sure the lid is secure before MUST BE EARTHED.
switching the kettle on.
● Note:
Warning: Do not remove the lid
●
while the water is boiling. For non-rewireable plugs the fuse
●
Take care when opening the lid - cover MUST be refitted when
replacing the fuse. If the fuse cover
droplets of hot water may be
ejected. is lost then the plug must not be
●
used until a replacement can be
Make sure the kettle is switched off
obtained. The correct fuse cover is
before lifting or pouring.
●
Remove the kettle from the base identified by colour and a
replacement may be obtained from
before filling or pouring.
your Kenwood Authorised Repairer
(see Service).
● ●
If a non-rewireable plug is cut off it If you experience problems
must be DESTROYED with your kettle switching on
IMMEDIATELY. An electric shock and off during use or
hazard may arise if an unwanted switching off before boiling,
non-rewireable pug is inadvertently check that the flat element is
inserted into a 13A socket outlet. free from scale - see
●
This kettle complies with European "descaling". If descaling
Economic Community Directive does not solve the problem
89/336/EEC. contact Kenwood customer
care.
before using for the first time
●
Your kettle is fitted with a scale filter
●
Adjust the length of the cord - pull
to hold back limescale particles.
the cord out of the base to
●
If you find drops of water under
lengthen. To shorten the cord turn
your kettle, don't worry - it is just
the handle on the underside of the
condensation.
powerbase clockwise.
●
Fill to 'MAX', boil, then pour the boil-dry protection
●
water away. Repeat 2 to 3 times. If you switch on with too little water,
your kettle will cut out automatically.
toknow your Kenwood
Switch off and let it cool down
before re-filling.
jug kettle
When it has cooled down, the
lid switch will reset itself.
scale filter
care and cleaning
water level gauges
on/off switch with neon
Before cleaning, unplug your kettle
360˚ powerbase
and let it cool down.
cord winder handle
the outside and powerbase
to use your jug kettle ●
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
1 Fill the kettle through the lid. The
scratch the metal and plastic
water level must be between 'Max'
surfaces.
and 200ml (1 cup).
the inside
●
Always use the filter and never
●
Wipe with bicarbonate of soda on a
overfill - boiling water may splash
damp cloth. Rinse thoroughly.
out.
●
Even though your kettle comes with
●
Be economical: do not boil more
a scale filter, you still need to clean
water than you need.
the inside (and the filter) regularly.
●
To improve the quality of your
the scale filter
drinks always use fresh water.
1 Remove the lid.
●
Empty the kettle after each use.
2 Slide the filter out
2 Check the lid is closed.
3 either rinse under the tap or use a
3 Plug in and switch on. The neon will
soft brush
come on.
or when descaling your kettle, drop
4 Your kettle will boil and switch off
the filter in too. Rinse thoroughly.
automatically. To re-boil, wait a few
4 Slide the filter back in to refit
seconds - the on/off switch needs
time to reset.
.
.