Manual Transport
When pushing or pulling the mower, engage the
ZT-2800 (Integrated Zeroturn Transaxle) bypass
linkages. The ZT-2800 bypass linkages are located on
the rear of the frame, below the rear engine guard.
1.
Raise the deck into the highest cutting position.
2.
Pull the ZT-2800 bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3.
To reengage the ZT-2800 to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIfT! The machine is not
intended to be lifted by hand.
WARNING!
Make no adjustments without:
•
the engine stopped,
•
the ignition key removed,
•
the parking brake activated
OPERATION
Bypass linkage, ZT-2800 engaged
Bypass linkage, ZT-2800 locked in the bypass position
8058-032
8058-032
33
Husqvarna-