Table of Contents
Advertisement
Manual Transport
When pushing or pulling the mower, engage the
transmission (Integrated Zeroturn Transaxle) bypass
linkages. The transmission bypass linkages are
located on the rear of the frame, below the rear engine
guard.
1. Raise the deck into the highest cutting position.
2. Pull the transmission bypass linkages up and
out of the keyhole slots. Release the levers
with the head outside the frame and held in the
bypass position.
3. To reengage the transmission to drive, reverse
the above procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNING!
Make no adjustments without:
•
the engine stopped,
•
the ignition key removed,
•
the parking brake activated
OPERATION
Bypass linkage, transmission engaged
Bypass linkage, transmission locked in the bypass position
8058-032
8058-033
33
Husqvarna-
Advertisement
Table of Contents
