Kenwood Multipro FP905 User Manual page 5

safety
G
The blades and discs are very sharp, handle
with care. Always hold the knife blade
by the finger grip
from the cutting edge, both when
handling and cleaning.
G
Do not lift or carry the processor by the handle - or the handle
may break resulting in injury.
G
Always remove the knife blade before pouring contents from the
bowl.
G
Keep hands and utensils out of the processor bowl and liquidiser
jug whilst connected to the power supply.
G
Switch off and unplug:
before fitting or removing parts
G G
G G after use
before cleaning
G G
G
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
G
Before removing the lid from the bowl or liquidiser/mill from the
power unit:-
G G switch off;
wait until the attachment/blades have completely stopped;
G G
G G Be careful not to unscrew the liquidiser jug or mill from the
blade unit.
G
Do not use the lid to operate the processor, always use the on/off
speed control.
G
This machine will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
G
This machine is not intended for use by young children or infirm
persons without supervision.
G
Never use an unauthorised attachment.
G
Don't let children play with this machine.
G
Never leave the machine on unattended.
G
Never use a damaged machine. Get it checked or repaired: see
'service'.
G
Never let the power unit, cord or plug get wet.
G
Don't let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
G
Never misuse your food processor and only use it for its
intended domestic use.
G
Do not exceed the maximum capacities stated.
before plugging in
G
Make sure your electricity supply is the same as the one shown
on the underside of your machine.
G
This appliance complies with European Economic Community
Directive 89/336/EEC.
at the top, away
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade
during manufacture and transit only.
2 Wash the parts see 'cleaning'
3 Push excess cord into the back of the machine.
key
processor
power unit
detachable drive shaft
bowl
lid
feed tube
pushers
safety interlocks
cord storage
speed control with power on light
liquidiser
filler cap
lid
lid seal (FP920)
jug – plastic (FP910) & Glass (FP920)
sealing ring
blade unit
additional attachments
Not all of these attachments listed below will be included with
your food processor. To buy an attachment not included in your
pack, contact the dealer from whom you purchased your
appliance.
knife blade
dough tool
twin beater geared metal whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
fine (Julienne style) chipper disc
rasping disc
geared citrus press
mill
mini processor bowl
centrifugal juicer
KENSTORE™ attachments carousel
spatula
2