Basic Operation - Packard Bell SLIM TV Owner's Manual

User's Guide
15.VIDEO
Selects the VIDEO mode.
16. S-VIDEO
Selects the S-VIDEO mode.
17. PC
Selects the PC mode.
18.TELETEXT Buttons
These buttons are used for TELETEXT.
For further details, see the 'TELETEXT' section.
B
ATTERY INSTALLATION
Inserting batteries
1. Remove the battery cover by pulling it upward in the direction shown by the arrow.
2. Insert the batteries with correct polarity ("+" to "+", and "-" to "-").
3. Replace the battery compartment cover.
• Install two high-quality 1.5V "AAA" alkaline batteries. Don't mix old batteries with new batteries.
• Remove batteries when you won't use the remote controller for long time. Liquid leakage from old batteries may cause operation failure.
Notes for using remote controller:
• Make sure there are no objects between the remote controller and its sensor.
• Don't place the remote control near a heater or in damp place. Strong impact to the remote control may cause operation failure.
• Signal from the remote control may be disturbed by sun light or other bright light. In this case, darken the room or move the TV.
T TV O
URNING THE N AND
Standby Setup:The AC-DC converter and the AC power cord must be set up and connected to have the TV in standby mode ready to be turned on.
Press the power button on the front panel of the TV to go into standby mode.
1. If the TV is in standby mode, press the Power button on the remote controller or the TV itself to turn the TV on.
2. Press the Power button again on the remote controller or the TV itself to turn the TV off.
Note: If the TV is on and the power button is pressed to turn the TV off, the TV goes into standby mode.
P
ROGRAMME SELECTION
You can select a Programme number with the PR
V
OLUME ADJUSTMENT
Press the VOL button to adjust the sound level.
Q
UICK VIEW
Press the Q.View button to view the last channel you were watching.
S
OUND MUTE FUNCTION
Press the MUTE button.The sound is switched off and the mute display
To cancel mute mode, press the MUTE button again, VOL
O
N SCREEN MENU LANGUAGE SELECTION
The menu can be displayed on the screen in desired language.
First select your language:
1. Press the MENU button.
2. Select the Setup menu.
3. Select the Language.
4. Press the PR button to select your desired language.
5. Press the TV/AV button.
All the on screen menus will appear in the selected language.
B
ASIC
O
FF
button or NUMBER buttons.
O
PERATION
appears.
or SSM button.
5
English