Belling Hob Rotary UK Users Manual & Installation Handbook page 12

clearances and dimension – require-
ments
No shelf or overhang of combustible
material should be closer than 650mm
above the hob.
There must be a minimum clearance of
50mm between the edges of the hob
and any side walls; this clearance must
be maintained up to 420mm above the
worktop.
*
650mm min
490mm (60 - 70cm Hobs) (
370mm (90cm Hobs)
*
Minimum height to extractor
as recommend in extractor
instruction manual
installation
Minimum distance
between carcasses must
be equal to width of hob
420mm min
50mm min
50mm Min
There must be a minimum clearance of
50mm between the rear edge of the hob
and the rear wall. This clearance must
be maintained up to 650mm above the
worktop.
When installing an extractor hood above
the hob, refer to their Manufacturer's
instructions.
560mm (60cm Hobs)
660mm (70cm Hobs)
860mm (90cm Hobs)
50mm min
30mm min /
50mm max