18
Using the DSP8000
Selecting a source
loudspeakers
When not playing, the DSP8000 loudspeakers should
be left in the standby state. This uses a negligible
amount of electricity, but ensures that the components
of the loudspeakers operate at maximum efficiency
from the moment you start.
If you are not going to use the DSP8000 loudspeakers
for several days you should switch each unit completely
off at the back panel, and disconnect it from the AC
power supply.
To select a source
•
Press the appropriate source key on the remote; eg
Radio.
This will bring the DSP8000 loudspeakers out of
standby, and the displays will show the currently
selected source and volume setting.
For example:
Initially all the sources are set to use the SpeakerLink
digital input. To configure all sources to use the co-axial
input, configure the speaker as M.Coax or S.Coax;
see To choose master or slave and the primary
connector , page 24. To configure an individual source
to use a different input see To configure a source , page
27.
Radio 65
To switch to standby
•
Press Off on the remote.
The loudspeakers will switch to standby.
The displays will show:
.