Configuring The Setup Options - Meridian DSP8000 User Manual

28
Configuring

Configuring the setup options

the DSP8000
loudspeakers
The setup options allow you to adjust the frequency
response of the loudspeakers to compensate for
their position. You only need to configure the master
loudspeaker.
When configuring the DSP8000 loudspeakers,
point the remote at the speakers, even if you have a
Meridian Surround Controller.
To select Setup mode
• Turn off the DSP loudspeaker using the power switch
on the back panel.
• Turn on the power again while holding down the
Store key on the remote.
The display will show:
It will then revert to standby:
The display shows:
You can now operate the speaker in the usual way,
using the additional setup menus to adjust the
response while listening to sources.
When you have finished adjusting the setup options:
• Switch off at the back panel, and then switch on
again to restore normal operation with the setup you
have programmed.
Setup
.
To adjust the frequency response
• Press Function > or Function < until the display
shows the current response setting.
For example:
• Press Function A or Function V to select the
appropriate option as follows:
Option
Free
Boundary
Sub.1
Sub.2
Corner
Free
What it means
Flat frequency
response.
Speaker closer than
0.5m (20") to a wall.
Applies a second-order
high-pass filter at
80Hz for use with an
analogue subwoofer.
Applies a second-order
high-pass filter at
120Hz for use with an
analogue subwoofer
Speaker closer than
0.5m (20") to a corner.