Selecting A Source - Meridian DSP8000 User Manual

18
Using the DSP8000

Selecting a source

loudspeakers
When not playing, the DSP8000 loudspeakers should
be left in the standby state. This uses a negligible
amount of electricity, but ensures that the components
of the loudspeakers operate at maximum efficiency
from the moment you start.
If you are not going to use the DSP8000 loudspeakers
for several days you should switch each unit completely
off at the back panel, and disconnect it from the AC
power supply.
To select a source
• Press the appropriate source key on the remote; eg
Radio.
This will bring the DSP8000 loudspeakers out of
standby, and the displays will show the currently
selected source and volume setting.
For example:
Initially all the sources are set to use the RJ45 digital
input. To configure all sources to use the co-axial input,
configure the speaker as M.Coax or S.Coax; see
To choose master or slave and the primary connector ,
page 24. To configure an individual source to use a
different input see To configure a source , page 27.
Radio 65
To switch to standby
Press Off on the remote.
•
The loudspeakers will switch to standby.
The displays will show:
.