26
Configuring
Specifying information about your system
the DSP8000
loudspeakers
You can configure the operation of the DSP
loudspeakers to suit the way your system is set up, and
the way in which you want to use it.
These settings are configured automatically to
appropriate values when you choose one of the
standard Type settings, and you should not normally
need to alter them; see To select a standard setting ,
page 24.
To configure the DSP loudspeaker
•
Turn off the DSP loudspeaker, using the power
switch on the back panel.
Turn on the power again while holding down the 0
•
key on the remote.
The display will show the current setting of the first
configuration option.
For example:
•
Press > or < to step between the options.
•
Press A or V to change the value of the current
option.
The following table shows the options you can
configure:
L.M.RJ45
Option
Initial value in Type 1
Position and master/
L.
slave
Compatibility (G, 500,
G
200 Pre, or 200 CD)*
Controller mode (Auto,
Auto
Con, or NCon)
System address (1–8)
S.A.
Product address (1–8)
P.A.
Volume mode
L.E.
(1=normal, 2/3=second
or additional room)
Balance control
Bal.
(N or Y)
Centre menus? (N or Y)
Centre N
Diagnostic displays?
Diag.
(N or Y)
* G gives 500 and 800 Comms and MSR+ sources,
500 gives 500 Comms and MSR sources, and 200
Pre or 200 CD are legacy modes.
1
1
1
Y
N