Maytag MVWB980BG0 Installation Instructions Manual page 8

Adjust leveling feet
5, Plug into a grounded
3-prong outlet
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and repeat
as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
_4. Tighten leveling feet
When washer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
on leveling feet tightly against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
8
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
COMPLEWE INSTALLATION
[]
m
[]
[]
m
[]
[]
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
See "Electrical Requirements."
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Check that you have all of your tools.
Keep the foam packing ring from the washer tub for future
relocation of the washer. Dispose of/recycle all packaging
materials.
Check that both water faucets are on.
Check for leaks around faucets and inlet hoses.
Remove film from console and any tape remaining
on washer.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
[]
[]
[]
Check that washer is plugged into a grounded
3-prong outlet.
Read "Washer Use" in your "Use and Care Guide."
To test and clean your washer, measure 1/2 of normal
recommended amount of High Efficiency (HE) powdered
or liquid detergent for a medium-size load and pour it into
detergent dispenser. Close lid. Press POWER. Select
a normal cycle and press START. Allow it to complete
one whole cycle.