Maytag MGT8655XS03 Installation Instructions Manual page 17

To Convert Oven Broil Burner
1. Remove broil burner screw and set aside.
2. Remove the broil burner from the broil burner orifice hood.
The broil burner will hang in the back of the oven while
changing the orifice hood.
B
3,
A. Broil burner screw
B. Broil burner orifice hood
Turn the green Number 0.037 LP gas broil burner orifice hood
counterclockwise to remove.
5. Place the broil burner on the broil burner orifice hood. Insert
the broil burner Iocator pin in the hole in the oven back.
6. Position the broil burner against the roof of the oven cavity
and attach with screw.
A B
J
A. Broil burner orifice hood
B. Broil burner
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or Torx ®screwdriver, remove the burner base.
4,
A. Number 0.037 LP gas broil burner orifice hood
Install the Number 0.054 Natural gas broil burner orifice hood,
turning it clockwise 4 or 5 turns. Do not overtighten.
i ..................
A. Number 0.054 Natural gas broil burner orifice hood
4,
A. Burner cap C. Burner base screws
B. Gas tube opening D. Burner base
Apply masking tape to the end of a %2" (7.0 mm) nut driver to
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A
A. LP gas orifice spud
Use the following chart for correct Natural gas orifice spud for
each burner. Refer to the model/serial rating plate behind the
control panel for proper sizing of Natural orifice spuds for each
burner location.
17