Table of Contents
Advertisement
WARNING
--"Ri kofFir°"
- Clothes dryer installation
must be performed
by a qualified
installer.
= Install the clothes dryer according
to the manufacturer's
instructions
and local codes.
= Do not install a clothes dryer with flexible
plastic venting materials
or flexible
metal
(foil type) duct. if flexib(e
meta( duct is installed,
it must be of a specific
type identified
by the appliance
manufacturer
as suitable for use with clothes dryers. F(exibie venting
materials
are known to collapse,
be easily crushed,
and trap lint. These conditions
will
obstruct
clothes dryer airflow and increase the risk of fire.
- To reduce the risk of severe injury or death, follow
all installation
instructions.
= Save these
instructions.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other
reproductive harm.
INSTALLATION REQUIREMENTS
Steam Models
Tools and Parts
Gather the required tools and parts before starting installation. Read
and follow the instructions provided with any tools listed here.
•
Flat-blade screwdriver
•
Caulking gun and compound
(for installing new exhaust
•
#2 Phillips screwdriver
vent)
•
Adjustable wrench that
opens to 1" (25 mm) or
•
Tin snips (new vent
hex-head socket wrench
installations)
(for adjusting dryer feet)
•
1/4" nut driver
•
Level
(recommended)
•
Wire stripper (direct wire
•
Tape measure
installations)
•
Pliers
•
Vent clamps
Parts supplied
Non-SteamModels
4 Leveling legs
Remove parts package from dryer drum. Check that all parts are
included.
NOTE: Do not use leveling legs supplied with dryer if installing
on a pedestal.
A. Leveling legs (4)
B. "Y" connector
C. Short inlet hose
D. Long inlet hose
E. Rubber washer
Remove parts package from dryer drum. Check that all parts are
included.
NOTE: Do not use leveling legs supplied with dryer if installing
on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your Use and Care Guide.
2
Advertisement
Table of Contents
