Setting The Parameters; Configure - Avaya P133G2 Quick Start Manual

Assigning the Stack IP Address
Commands are shown as follows: set interface inband;
parameters which you need to enter are shown in <> as follows: <vlan>
1. Type set interface inband <vlan> <ip_address> <netmask> replacing
<vlan>, <ip_address> and <netmask> with the VLAN, IP address and net mask of
the stack and press Enter.
2. Type reset and press Enter to reset the stack.
3. After the Reset, perform login again as described above.
The P130-N(super)# prompt appears.
4. Type set ip route <destination> <gateway> , replacing <destination> and
<gateway> with the destination and gateway IP addresses.
5. Press Enter to save the destination and gateway IP addresses.

Setting the Parameters

If you wish to change the default parameters shown and configure the mandatory
parameters, we recommend that you use the Command Line Interface (CLI).
For further information, please refer to Chapter 6 of the Avaya P130 Documentation.
5